How do you adjust the diamond infinite edge?
The Diamond Infinite Edge Pro has the ability to be adjusted from 31 inches of draw length down to 13 inches of draw length. To enable the full range of adjustability, there is an “A” setting, a “B” setting, and a “C” setting available on the cam’s string posts.
How do you change the weight on a diamond edge 320?
Draw weight on the Diamond Edge SB-1 is adjustable from 70 pounds downward to 7 pounds. Draw weight can be adjusted by using a 1/4 inch hex wrench to either tighten or loosen the limb bolt. The draw weight should be adjusted equally on top and bottom limb bolt.
How do I know my draw length?
To measure your draw length, stand with your back to a wall stretching your arms out against the wall. Measure the distance from the end of your middle finger to the end of your other middle finger, basically the length of both arms, hands and chest. This measurement, minus 15 then divided by 2, is your draw length.
How do you adjust the draw length on diamond black ice?
Unlike most bows on the market today, Diamond bows do not require a new cam or module to set your draw length. Simply remove the mod screws, rotate the module, and re-tighten. At least six inches of draw length adjustment is available on most models, allowing for custom draw length tuning for yourself or others.
What is the difference between the diamond infinite edge and the pro?
The Infinite Edge is the first generation of this lineup. While there were some improvements made in the Pro, the first generation Edge is largely the same. It has a bit smaller axle to axle measurement, and only goes to a 30” draw length. Finally, the Edge has a 75% let-off compared to the Pro’s 80%.
What year is the diamond Infinite Edge Pro?
|Bow||Diamond Infinite Edge Pro||Mission Riot|
|Brace Height||7 “||7 “|
|AtA Length||31 “||31 “|
How fast is a diamond infinite edge bow?
Compared to Similar Bows
|Bow||Diamond Infinite Edge||Mission Menace|
|AtA Length||31 “||31 “|
|Draw Length||13 ” – 30 “||17 ” – 30 “|
|Draw Weight||5 lbs – 70 lbs||16 lbs – 52 lbs|
|IBO Speed||310 fps||fps|
Is 70 lb draw too much?
For example, a bow with a 70-pound peak weight and a 80% let-off should have a holding weight of around 14-pounds. … Being able to hold a bow at full draw for 30 seconds is great, but if you’re shaking, struggling, and exhausted at the end of that time, then you’re not going to be able to make an ethical shot.
Does changing draw weight change draw length?
The weight of a bow (the ‘poundage’) is always measured at a standard 28″ draw length, but that weight changes at different draw lengths. … If your own draw length is over 28″, then the actual weight of a bow will be higher than it is listed at (conversely, if your draw length is less, the bow weight will be less).
Does changing draw weight change sights?
Increasing your draw weight can change your arrow’s tuning, and you’ll likely have to adjust your sight. While you’re at the archery shop, talk to the bow technician about your desired draw weight and buy the arrow spine they suggest.